Yamaha MY8-LAKE MY8-LAKE Owners Manual - Page 21
Changing the MY8-LAKE Frame Configuration, Tap the [Contour Reset] button
View all Yamaha MY8-LAKE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
This stores all module information (levels, x-over and EQ settings) from the selected module as a new module file for future recall. You can recall the file and overwrite a different module. 4. Tap the [Home] button, then tap the [System Store/Recall] button. 5. Tap the [Store System] button, then enter a system name, and finally tap [OK] (or press ). This stores all data (frame and module data) in your current system before proceeding to change the device configuration. Input and output routing settings as well as input mixer settings are part of frame data. We recommend you get into a habit of regularly saving your work to minimize the risk of data loss. NOTE For further information about storing of Module files, Base Configuration files, System and Sub-System files, refer to the Lake Controller Operation Manual. Changing the MY8-LAKE Frame Configuration To review the functionality of the MY8-LAKE card in loudspeaker processor (Contour) mode, the MY8-LAKE Frame configuration must be changed from the default Mesa mode to Contour mode. 1. Tap the [Home] button, then tap the [Modules] button. 2. Make sure that a module is selected, then tap the [I/O Config] button, and finally the [Frame Config] button. 3. Tap the [Contour Reset] button, then tap [Yes] after reading the important warning dialog. The screen changes to show the module scroll bar and the reconfigured modules will appear on the scroll bar after a few seconds. The Frame can be configured using any of the three available reset options shown above as required. 4. Select one of the MY8-LAKE Contour modules from the module scroll bar and place it in the main work area. The default 4 x Classic 2-Way Crossover modules appear as shown below. MY8-LAKE Owner's Manual 21