Yamaha NX-B150 NX-B150 Owners Manual - Page 14

Troubleshooting, General, AUTO STANDBY

Get Yamaha NX-B150 PDF manuals and user guides View all Yamaha NX-B150 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Troubleshooting Refer to the table below if this unit does not operate properly. If your problem is not listed below, or if the problem persists, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center. ■ General Problem No sound is output from either or both of the speakers, or the sound is too quiet. Cause p (power) is not turned on. The speakers are not connected properly, or this unit and the connection device are not connected properly. (Or, the contact is incomplete.) The volume on this unit is too low. The volume on the connection device is too low. Solution Turn on p (power). When the power is on, p (power) lights white. Make sure the speakers are connected properly. (☞ page 10) Or, reestablish a Bluetooth connection. (☞ page 13) Increase the volume by pressing + (volume). Increase the volume on the connection device. ■ AUTO STANDBY Problem The auto-standby function does not work. The auto-power on function does not work. Cause The AUTO STANDBY switch is set to OFF. The volume on the connection device is too low. Solution Set the AUTO STANDBY switch to ON. (☞ page 11) Increase the volume on the connection device. 14 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
14
En
Refer to the table below if this unit does not operate properly. If your problem is not listed below, or if the problem persists, turn off this unit, disconnect the
power cable, and contact the nearest authorized Yamaha dealer or service center.
■
General
■
AUTO STANDBY
Troubleshooting
Problem
Cause
Solution
No sound is output from
either or both of the
speakers, or the sound is
too quiet.
p
(power) is not turned on.
Turn on
p
(power).
When the power is on,
p
(power) lights white.
The speakers are not connected properly, or this unit and
the connection device are not connected properly. (Or, the
contact is incomplete.)
Make sure the speakers are connected properly. (
☞
page 10)
Or, reestablish a
Bluetooth
connection. (
☞
page 13)
The volume on this unit is too low.
Increase the volume by pressing + (volume).
The volume on the connection device is too low.
Increase the volume on the connection device.
Problem
Cause
Solution
The auto-standby
function does not work.
The
AUTO STANDBY
switch is set to
OFF
.
Set the
AUTO STANDBY
switch to
ON
.
(
☞
page 11)
The auto-power on
function does not work.
The volume on the connection device is too low.
Increase the volume on the connection device.