Yamaha P-100 Owner's Manual (image) - Page 45

Bulk protect

Page 45 highlights

Bulk protect The bulk protect function protects the P-100's internal settings against incoming system exclusive messages. When this function is turned on, as is normally the case, the P-100 will not accept any incoming bulk dump or parameter change messages. When it is set to bulk ("bul"), the P-100 will accept parameter change messages, but protect against bulk messages. Finally, when turned off, the P-100 will allow its memory to be overwritten by incoming bulk dumps and system exclusive messages. 1. Enter MIDI Utility mode. Press the [PROTECT] button while holding down the [MIDI] button. The current bulk protect setting will appear in the display. 2. Set the desired value. Use the [DATA ENTRY] slider or the [-l] and [+l] buttons to switch the setting to the desired value. 3. Exit MIDI Utility mode. Press the [MIDI] button to exit MIDI Utility mode. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69

Bulk protect
The bulk protect function protects the P-100’s internal settings against incoming system exclusive messages.
When this function is turned on, as is normally the case, the P-100 will not accept any incoming bulk dump or param-
eter change messages. When it is set to bulk (“bul”), the P-100 will accept parameter change messages, but protect
against bulk messages. Finally, when turned off, the P-100 will allow its memory to be overwritten by incoming bulk
dumps and system exclusive messages.
1.
Enter MIDI Utility mode.
Press the [PROTECT] button while holding down the [MIDI]
button. The current bulk protect setting will appear in the
display.
2. Set the desired value.
Use the [DATA ENTRY] slider or the [-l] and [+l] buttons to
switch the setting to the desired value.
3.
Exit MIDI Utility mode.
Press the [MIDI] button to exit MIDI Utility mode.
36