Yamaha P-100 Owner's Manual (image) - Page 51
Program change receive table
View all Yamaha P-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Program change receive table The P-100 is also capable of changing its current voice selection in response to program change messages it receives from external devices. Before it left the Yamaha factory, your P-100 was set so that program change numbers 1 through 10 will select the corresponding voices: program change 1 will select PIANO 1, program change 2 will select PIANO 2, and so on. Program change numbers above 10 were set to have no effect. These settings are grouped in a table known as the program change receive table. This is a table which assigns a P-100 voice selection to each of the 128 program change numbers. The procedure for changing the assignments in this table is described below. 1. Enter MIDI Utility mode. Press the [PC RECV] button while holding down the [MIDI] button. A program change number will appear in the display, and the LED above the [VOICE/UTILITY] button which has been assigned to this program change number will light. (If no button has been assigned to the program change number in question, none of the [VOICE/UTILITY] button LEDs will light.) 2. Select a program change number. Use the [DATA ENTRY] slider or the [-1] and [+l] buttons to select the desired program change number, or jump to step 3 if you wish to change the setting for the current program change number. You can select any program change number from 1 to 128. If you wish, you can make your selection using a MIDI message instead of the [DATA ENTRY] slider. To do this, have an external device transmit the desired program change number on the P-100's program change receive channel. The number of the message you send will appear in the P-100's display. When you select a program change number, the LED above the [VOICE/UTILITY] button for the voice which has been assigned to that number will light. (Again, if no button has been assigned to the program change number in question, none of the [VOICE/UTILITY] button LEDs will light.) 3. Select a voice. Press the [VOICE/UTILITY] button for the voice you wish to assign to the program change number you have selected. The LED above the button you press will light. You can also turn the program change receive function off for the selected program change number by pressing the button a second time. When you do so, the LED above the button will go out. 42