Yamaha PF-500 Owner's Manual - Page 101

4. Raising the stand to the standing position. Use the front legs as support to raise the stand. CAUTION Be careful not to pinch your fingers. 5. Mounting the keyboard. Assembling the Keyboard Stand 7. Connecting the pedal unit. 1 Place the pedal unit in front of the rear legs. 2 PEDAL 3 2 Connect the pedal cord plug into the PEDAL jack on the left side of the keyboard, with the arrow on the plug facing up. 3 Attach the cord holders in the position shown in the illustration, and clip the pedal cord to the holders. * You can also clip the power cord to the cord holders. 8. Set the voltage selector and connect the power cord to the AC INLET on the keyboard. AC INLET Be sure to hold the four corners of the keyboard. Mount the keyboard so that the rubber feet on the bottom of the keyboard fall into the holes on the stand. CAUTION Be careful not to pinch your fingers or drop the keyboard. CAUTION Do not hold any part of the keyboard other than four corners as shown in the illustration. 6. Fixing the keyboard. Attach the cap bolts on the bottom of the stand and tighten them with your hand to fix the keyboard. VOLTAGE SELECTOR Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector (provided in some locations). To set the selector for 110V, 130V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may also be provided in some areas to match the pin configuration of the AC wall outlets in your area. WARNING An improper voltage setting can cause serious damage to the PF500 or result in improper operation. After completing the assembly, please check the following. • Are any parts left over? • Review the assembly procedure and correct any errors. • Is the PF-500 clear of doors and other movable fixtures? • Move the PF-500 to an appropriate location. • Does the PF-500 make a rattling noise when you shake it? • Tighten all screws. • Are the pedal and power cords inserted securely into the sockets? • Check the connections. • If the keyboard stand creaks or is otherwise unsteady when you play the keyboard, refer to the assembly diagrams and retighten all screws. PF-500 101