Yamaha R-S300 Owners Manual - Page 18

PLAYING AND RECORDING PLAYING AND RECORDING CAUTION Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a CD player that does not support DTS, only noise will be heard, and this noise may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS. Playing a source 3 Press SPEAKERS A and/or SPEAKERS B on the front panel or on the remote control to select speakers A and/or speakers B. When speaker set A or speaker set B are turned on, SP A or SP B is displayed on the front panel display accordingly (see page 6). SPEAKERS A/B A (power) INPUT selector VOLUME Notes • When one set of speakers is connected using bi-wire connections, or when using two sets of speakers simultaneously (A and B), make sure SP A and SP B are displayed on the front panel display. • When listening with headphones, turn off the speakers. A (power) SPEAKERS A/B Input selector buttons FM, AM 4 Play the source. 5 Rotate the VOLUME control on the front panel (or press VOLUME +/- on the remote control) to adjust the sound output level. y You can adjust the tonal quality by using the BASS, TREBLE, BALANCE and LOUDNESS controls, or the PURE DIRECT switch on the front panel (see page 15). VOLUME +/- 6 When finished listening, press A (power) on the front panel outward to turn off this unit. y If A (power) on the remote control is pressed while the A (power) button on the front panel is in the on position, this unit enters standby mode. Press A (power) again to turn this unit on. 1 Press A (power) on the front panel inward to turn on this unit. 2 Rotate the INPUT selector on the front panel (or press one of the input selector buttons or FM or AM on the remote control) to select the input source you want to listen to. 14 En