Yamaha RMio64-D RMio64-D Owners Manual [English] - Page 13
Connecting AC Power, Power on and off
View all Yamaha RMio64-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Using Optical Cables NOTE Optical cables of up to 2,000 meters (theoretical value) can be used. RMio64-D OPTICAL OUT OPTICAL IN OPTICAL IN OPTICAL OUT MADI-compatible device Redundant Connection (Input only) You can set up a redundant connection using both 75Ω coaxial cables and optical cables, so that there is no input signal loss even if interference occurs in the connection. In addition, the input signal from the Dante network is output from both the MADI [COAXIAL OUT] and MADI [OPTICAL OUT] connectors, regardless of the MADI redundancy settings. Settings • To set up a redundant connection, turn on MADI DIP switch 2 (DOWN). • To give priority to the coaxial cables, turn on MADI DIP switch 1 (DOWN). • To give priority to the optical cables, turn off MADI DIP switch 1 (UP). NOTE Make sure to change the settings of the DIP switches while the power to the unit is turned off; otherwise, the ID setting will not be effective. RMio64-D Connecting AC Power 1. Turn the unit off. 2. Connect the plug on the AC power cord to the AC IN connector on the rear panel of the unit. 3. Connect the other side of the plug on the AC power cord to a power supply socket. NOTE • When removing the AC power cord, perform these steps in reverse. • Press the latch button on the plug to disconnect the power cord. WARNING • The RMio64-D has been designed assuming it a proper ground connection is used. To prevent electrical shock and damage to devices, use the included AC power cord to create a secure ground connection. If you do not know how to make a proper ground connection, contact a Yamaha service center listed at the end of this manual. • Be sure to use only the included power cord with this unit. Use of a different power cord could result in abnormal heat and electrical shock. CAUTION • Be sure to turn the power off before connecting or disconnecting the power cord. • Even when the power switch is turned off, a small amount of current is flowing through the unit. When you are not using the product for a long time, make sure to unplug the power cord from the power supply outlet. Power on and off When turning on the AC power in your audio system, always turn on the power amplifier LAST, to avoid speaker damage. When turning the power off, the power amplifier should be turned off FIRST for the same reason. Coaxial cable priority Optical cable priority MADI-compatible device When using the word clock input from the MADI [WCLK IN FOR SRC] connector as the MADI SRC reference clock, the redundant function is unavailable. RMio64-D Owner's Manual 13