Yamaha RX V1900 Owner's Manual - Page 84
VIDEO MENU, Audio settings - factory reset
UPC - 027108930794
View all Yamaha RX V1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Customizing this unit (MANUAL SETUP) ■ Audio settings E)AUDIO SET Tone bypass TONE BYPASS Use this feature to select whether the audio output bypasses the tone control circuitry when "TREBLE" and "BASS" are set to 0 dB (page 46). Choice Functions AUTO Automatically bypasses the tone control circuitry to provide the purest signal possible when "TREBLE" and "BASS" are set to 0 dB. OFF Does not bypass the tone control circuitry. HDMI audio HDMI AUDIO Use this feature to select the types of the audio signals output at the HDMI OUT jack on the rear panel of this unit. Choice Functions AMP Outputs audio signals that can be decoded by this unit. AMP+TV Outputs audio signals that can be decoded by your video monitor connected to the HDMI OUT jack of this unit. Note Available audio/video signals depend on the specification of the connected video monitor. Refer to the instruction manuals of your video monitor and audio source component. ■ Pure direct F)PURE DIRECT Use this feature to select whether this unit outputs the video signals when this unit is in the Pure Direct mode. Choice Functions AUDIO Does not Output video signals. AUDIO+VID EO Outputs video signals. For the better sound quality, this unit only activates the limited video features. Note You cannot use the OSD menu even if "PURE DIRECT" is set to "AUDIO+VIDEO". 4 VIDEO MENU Use this feature to adjust the video parameters. y You can reset the all parameters in "VIDEO MENU" to the initial factory settings by using "VIDEO" of "INITIALIZE" in "ADVANCED SETUP" (page 103). Video conversion VIDEO CONV. Use this feature to set whether to convert the video signals input at the VIDEO, S VIDEO, and COMPONENT VIDEO jacks. Choice Functions ON Converts composite, S-video, and component video signals interchangeably and up-converts composite, S-video, and component video signals to HDMI video signals. OFF Does not convert any signals. Notes • This unit does not convert 480 line video signals and 576 line video signals interchangeably. • 480p-, 576p-, 1080i- and 720p-resolution video signals cannot be output at the S VIDEO and VIDEO MONITOR OUT jacks. • The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component. • When composite video or S-video signals from a VCR are converted into component video signals, the picture quality may suffer depending on your VCR. • Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set "VIDEO CONV." to "OFF". Component interlace/progressive up-conversion COMPONENT I/P Use this feature to activate or deactivate the analog interlace/progressive conversion of the analog video signals input at the composite video, S-video and component video jacks so that the analog video signals deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p are output at the COMPONENT MONITOR OUT jacks. Choice Functions ON Activates the analog interlace/progressive up- conversion of the analog video signals. OFF Deactivates the analog interlace/progressive upconversion of the analog video signals. 80 En