Yamaha RX-V363 Owner's Manual - Page 63

■ Remote control Troubleshooting Problem The remote control does not work nor function properly. Cause Remedy Wrong distance or angle. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. The remote control code is not correctly set. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. The remote control functions within a maximum range of 6 m (20 ft) and no more than 30 degrees off-axis from the front panel. Reposition this unit. Replace all batteries. Set the remote control code correctly using "List of remote control codes" at the end of this manual. Try setting another code for the same manufacturer using "List of remote control codes" at the end of this manual. See page 21 - 3 53 53 ■ Resetting the system Use this feature to reset all the parameters of this unit to the initial factory settings. 1 Press ASTANDBY/ON on the front panel to set this unit to the standby mode. 2 Press and hold JTONE CONTROL and then press ASTANDBY/ON to turn on this unit. The advanced setup menu appears in the front panel display. Notes • This procedure completely resets all the parameters of this unit including the set menu parameters. • The initial factory settings are activated next time you turn on this unit. y To cancel the initialization procedure at any time without making any changes, press LSTRAIGHT repeatedly to select "CANCEL" and then press ASTANDBY/ON. 3 Press KPROGRAM l / h to select "PRESET". 4 Press LSTRAIGHT repeatedly to select "RESET". Select "CANCEL" to cancel the initialization procedure without making any changes. 5 Press ASTANDBY/ON to confirm your selection and set this unit to the standby mode. ADDITIONAL INFORMATION English 59 En