Yamaha RX V463 Owner's Manual - Page 24

Connections Connecting the FM and AM antennas Both FM and AM indoor antennas are supplied with this unit. Connect each antenna correctly to the designated terminals. In general, these antennas should provide sufficient signal strength. y See right for connection information of the supplied AM loop antenna. Notes • The AM loop antenna should be placed away from this unit. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. • A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas. Connecting the wire of the AM loop antenna Open the lever Insert Close the lever y The wire of the AM loop antenna does not have any polarity and you can connect either end of the wire to AM or GND terminal. Assembling the supplied AM loop antenna Outdoor AM antenna Use a 5 to 10 m (16 to 33 ft) vinyl-covered wire extended outdoors from a window. AM loop antenna (supplied) Indoor FM antenna (supplied) S DOCK L ANTENNA AM R GND FM 75 UNBAL. Note The types of the supplied AM loop antenna is different depending on the models. Connecting the power cable Once all connections are complete, plug the power cable into the AC wall outlet. (U.S.A. model) SUB WOOFER TPUT CENTER (U.S.A. model) Ground (GND terminal) For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. Power cable 20 En