Yamaha RX V995 Owner's Manual - Page 26
Speakers, How to Connect - instructions
UPC - 027108908069
View all Yamaha RX V995 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
PREPARATION Speakers Use speakers with the specified impedance shown on the rear of this unit. Subwoofer system Rear speakers Right Left Center speaker REMOTE IN CONTROL OUT OUTPUT CENTER REAR CENTER SPEAKERS REAR (SURROUND ) SUB WOOFER (SURROUND) OUTPUT MAIN CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. MAIN A A B B (U.S.A. model) IMPEDANCE SELECTOR SET BEFORE POWER ON CENTER : 4ΩMIN. / SPEAKER REAR : 6ΩMIN. / SPEAKER MAIN A OR B : 4ΩMIN. / SPEAKER A B : 8ΩMIN. / SPEAKER CENTER : 8ΩMIN. / SPEAKER REAR : 8ΩMIN. / SPEAKER MAIN A OR B : 8ΩMIN. / SPEAKER A B :I6ΩMIN. / SPEAKER Right Left Main speakers B Right Left Main speakers A How to Connect: Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is the + and - markings are observed. If these wires are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the speakers, or both. Red: positive (+) Black: negative (-) 2 1 3 Loosen the knob. Insert the bare wire. [Remove approx. 5mm (1/4") insulation from the speaker wires.] Tighten the knob and secure the wire. Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal. 22