Yamaha Ri8-D Ri8-D/Ro8-D Owners Manual [English] - Page 13
Rear Panel
View all Yamaha Ri8-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English Rear Panel C D EF Rear Panel G C AC IN Connector Connect the supplied AC power cord here. First, connect the power cord to the device, then insert the power cord plug into the AC outlet. The supplied power cord features a special latching mechanism (V-LOCK) to prevent the power cord from being accidentally disconnected. Connect the power cord by inserting the power cord fully until it is locked. CAUTION: Be sure to turn the power off before connecting or disconnecting the power cord. Press the latch button on the plug to disconnect the power cord. D [PRIMARY]/[SECONDARY] Connectors The Ri8-D/Ro8-D can be connected to other Dante-compatible devices (such as a CL-series product) via these RJ45 connectors using standard Ethernet cables (CAT5e or better recommended). If DIP switch 4 on the front panel is set upward (to DAISY CHAIN), audio signals coming into one of these connectors will be output from the other. Refer to "Daisy Chain Network" in the "About Connections" section (see page 14) for more information on daisy chain connections. If DIP switch 4 on the front panel is set downward (to REDUNDANT), the [PRIMARY] connector will be used for primary connection, and the [SECONDARY] connector will be used for secondary (backup) connection. If the unit is unable to transmit signals through the [PRIMARY] connector for some reason (e.g., due to damage or accidental removal of the cable, or a failed network switch), the [SECONDARY] connector will automatically take over the connection. Refer to "About Redundant Networks" in the "About Connections" section (see page 14) for more information on redundant networks. NOTE • Use STP (shielded twisted pair) cable to prevent electromagnetic interference. Make sure that the metal parts of the plugs are electrically connected to the STP cable shield by conductive tape or comparable means. • Connect only Dante-compatible devices or GbE-compatible devices (including a computer). * Illustration shows Ri8-D. E [LINK/ACT] Indicators These indicators show the communication status of the [PRIMARY] and [SECONDARY] connectors. They flash fast if the Ethernet cables are connected properly. F [1G] Indicators These indicators light when the Dante network is functioning as Giga-bit Ethernet. G Grounding screw Grounding of chassis shall be sufficiently connected via a power supply cord as long as AC socket is grounded since the attached power supply cord is a triplex cable.In addition, connecting this screw to ground may prevent hum noise or interference noise. Owner's Manual 13