Yamaha Ri8-D Ri8-D/Ro8-D Owners Manual [English] - Page 15
About Dante Controller, Initializing the Ri8-D/Ro8-D
View all Yamaha Ri8-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ON English About Dante Controller Dante Controller is a software application that allows configuration and audio routing of Dante networks. Use this application if you plan to connect or set up Dante-enabled devices that do not feature Ri8-D/Ro8-D-native support. Please download the latest Dante Controller from the following website. Please note that Dante Controller Version 3.2.1 or later supports Ri8-D/Ro8-D. http://www.yamahaproaudio.com/ To run Dante Controller, a computer must feature a GbE-compatible Ethernet connector. Refer to the Dante Controller owner's manual for details on Dante Controller. In Dante Controller, make the following basic settings: • [Network View] → [Routing] → I/O patching • [Network View] → [Clock Status] → Word clock master setting • [Device View] → [Config] → Sampling rate setting About Dante Controller Initializing the Ri8-D/Ro8-D To return (initialize) the internal memory to its factory-set state, for example if you move the unit to a different location, proceed as follows. 1. Turn the unit off. 2. On the front panel, set DIP switch 5 and 6 down (INITIALIZE). 12345678 56 3. Turn the unit on. During initialization, the [SYSTEM] and [SYNC] indicators remain turned off. When initialization is complete, each indicator lights up. 4. Verify that initialization is completed, and turn the unit off. 5. Set DIP switches 5 and 6 (REMOTE) according to your setup. 6. Turn the unit on. The Dante settings and HA parameters will be initialized. Parameter Initialized setting Dante Word Clock Latency Encoding SECONDARY Port IP Address 48kHz (slave) Pull up/down None 1.0ms PCM 24bit Daisy Chain Auto (Link Local) Primary IP address Secondary IP address Device Label 0.0.0.0 0.0.0.0 Y0xx-Yamaha-Ri8-D(Ro8-D)nnnnnn *1 Channel Label HA HA GAIN -6dB +48V HPF GAIN COMPENSATION Off Off, 80Hz Off, -6dB *1 "xx" refers to a UNIT ID value, and "nnnnnn" refers to the lower six digits of the Dante Primary MAC Address. Owner's Manual 15