Yamaha SLG200 SLG200_Owners Manual - Page 8
Control Nomenclature, Power Switch, VOLUME Control, TREBLE Control, BASS Control, Display
View all Yamaha SLG200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Nomenclature l Control Section q Power Switch This switches the Silent Guitar's power ON/ OFF. Use a slightly long press (more than 0.5 sec.) to switch ON, and a longer press (more than 1 sec.) to switch OFF. * In addition to the power switch, the LINE OUT jack also switches power ON/OFF. (Insert plug → power ON, disconnect plug → power OFF) CAUTION • Before switching the power ON/OFF, make sure that the power is switched OFF or the volume fully lowered on the guitar amp or powered speakers. • Always remove the stereo inner earphones or headphones from your ears before switching the power ON/OFF. w VOLUME Control Controls the volume level. * Turn the VOLUME control knob to the left to lower the volume if the sound distorts when playing heavily. e TREBLE Control Adjusts the treble level. r BASS Control Adjusts the bass level. Set the e and r knobs to their center positions as shown in the illustration then increase or decrease their levels as needed. t TUNER Switch Switches the tuner function ON/OFF. With the power ON, press this switch to enter the tuner mode, then press again to leave the tuner mode and return to the play mode. * Sound output from the Silent Guitar and the AUX IN jack are both muted while in the tuner mode. * Refer to page 11 for instructions on how to use the tuner. y Display Displays information for power ON status, tuning, low battery warning, etc. Power ON → (the green round lamp in the center lights ) Low battery warning → (triangles flash alter- nately n ) u BLEND Control Mixes the signal from the pickup and the signal of the simulated body resonance produced by the SRT POWERED system. Turn fully to the left for 100% pickup signal, and fully to the right for 100% simulated resonance tone. i EFFECT Control Switches between the three effects, two reverb and chorus, and adjusts the amount of each effect. Turn the knob fully to the left, as shown in the illustration, to turn the effects OFF. Turning the knob to the right gradually increases the depth of the effect until it reaches the point at which it switches to the next effect at its lowest depth level. Continue turning the knob to the right to increase effect depth. • REV 1: Produces a reverb effect similar to what you experience when playing in a room. • REV 2: Produces a reverb effect similar to what you experience when playing in an auditorium. • CHO: Produces a chorus effect that sounds like two guitars or a 12-string guitar playing. o AUX Control Adjusts the signal level of the AUX IN jack. 8