Yamaha SW-3 Owner's Manual - Page 10

ADJUSTING VOLUME POWER OFF ON 2 HIGH CUT VOLUME 50 Hz I50 Hz 5 0 I0 1, 4 1 Set the VOLUME control to minimum. 2 Turn on the power supply to all the components. 3 Play any source and adjust the amplifier's volume control to the desired listening level. 4 Turn up the VOLUME control gradually to adjust the volume balance between this unit and the main speakers. 5 Adjust the HIGH CUT control to the position where the desired response can be obtained. Notes • Once the volume balance between this unit and the main speakers is adjusted, you can adjust the volume of your whole sound system by using only the amplifier's volume control. • For adjusting the VOLUME control and the HIGH CUT control, refer to "FREQUENCY CHARACTERISTICS" on the right hand. For effective adjustment of the HIGH CUT control First set this control at about the main speakers' rated minimum reproduceable frequency. Then turn up the VOLUME control gradually and set it at a level where you can obtain a little more bass effect than when this unit is not used. On the basis of this setting, if desired, adjust the VOLUME control and the HIGH CUT control again. * The main speakers' minimum reproduceable frequency can be looked up in the speakers' catalog or owner's manual. 10