Yamaha TSX-10 Owner's Manual - Page 27

Troubleshooting MP3/WMA file playback Problem MP3/WMA file in the USB device is not played. Cause The USB device is not recognized. If the solutions above do not resolve the problem, the USB device is not playable on this unit. Solution Set this unit to the standby mode, and turn it on again (☞ P. 6). Disconnect the device while this unit is in the standby mode. Then connect the device again and turn on this unit (☞ P. 6). Connect an AC adapter if supplied with the device. Try another USB device. Radio reception ■ FM/AM Problem The preset selecting function (☞ P. 16) does not work. The preset station settings have been cleared. ■ FM Problem Too much noise during stereo broadcast. Even with an outdoor antenna, radio wave reception is weak. (Sound is distorted.) ■ AM Problem Too much noise during broadcast. The auto tuning function (☞ P. 18) does not work. Cause The preset (memory) may have been erased. The power to this unit may have been lost more than a week. Cause The FM antenna may be connected improperly. The radio station you selected may be far from your area, or the radio wave reception is weak in your area. Multipath reflection or other radio interferences may have occurred. Cause The noise may be caused by atmospheric electricity, lightning, fluorescent lights, motors, or thermostat electric devices. If this unit is placed near a TV, the noise may be generated especially in the evening. The AM loop antenna may be connected improperly. Solution Preset radio stations again (☞ P. 17). Plug the power cable into the outlet firmly, and preset the stations again (☞ P. 6). Solution Make sure the FM antenna is connected properly (☞ P. 16). Try manual tuning to improve the signal quality (☞ P. 17) or use a multichannel outdoor antenna. Change the height, direction, or placement of the antenna. Solution Connect an outdoor antenna and establish a better grounding to decrease the noise. However, it is difficult to eliminate these types of noise. Place this unit away from a TV. Make sure the AM loop antenna is connected properly (☞ P. 16). ADDITIONAL INFORMATION English 23 En