Yamaha V2075 RX-V3075/V2075 Owners Manual - Page 129
Configuring the system settings (ADVANCED SETUP menu), Network, System, Multi Zone
View all Yamaha V2075 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
■ Network Displays the network information on the unit. IP Address Subnet Mask Default Gateway DNS Server (P) DNS Server (S) MAC Address Network Name Status IP address Subnet mask The IP address of the default gateway The IP address of the primary DNS server The IP address of the secondary DNS server MAC address Network name (the unit's name on the network) (p.121) The connection status of the NETWORK jack ■ System Displays the system information on the unit. Remote ID The unit's remote control ID setting (p.130) TV Format The unit's video signal type (p.131) Speaker Impedance The speaker impedance setting of the unit (p.130) System ID System ID number Firmware Version The version of firmware installed on the unit • If the unit detects a newer firmware over the network, "!" (exclamation mark) appears at the upper right of the "Information" and "System" icons, and the corresponding message will be displayed in this screen. You can update the unit's firmware by pressing ENTER in this screen and following the procedure in "Updating the unit's firmware via the network" (p.141). ■ Multi Zone Displays information about Zone2, Zone3 and Zone4. Input Volume The input source selected for Zone2, Zone3 or Zone4 The volume for Zone2 or Zone3 Configuring the system settings (ADVANCED SETUP menu) Configure the system settings of the unit while viewing the front display. 1 Set the unit to standby mode. 2 While holding down STRAIGHT on the front panel, press MAIN ZONE z. MAIN ZONE z STRAIGHT PROGRAM 3 Press PROGRAM to select an item. 4 Press STRAIGHT to select a setting. 5 Press MAIN ZONE z to set the unit to standby mode and turn it on again. The new settings take effect. CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu) En 129