Yamaha V2075 RX-V3075/V2075 Owners Manual - Page 53

1 2 3 4 5 6 7 8 9 Automatic speaker setup SOURCE RECEIVER AV 1 2 3 5 6 7 AUDIO 1 2 3 PHONO TUNER 1 MULTI USB [ A ] [B] SCENE 2 3 4 V-AUX 4 NET [ C ] 4 PROGRAM MUTE VOLUME TOP MENU ON SCREEN POP-UP/MENU OPTION ENTER RETURN DISPLAY MODE Cursor keys ENTER RETURN PRESET INPUT MUTE CLASSICAL MOVIE TV TV VOL LIVE CLUB STEREO TV CH ENTERTAIN STRAIGHT PURE DIRECT Measuring at one listening position (single measure) When "Multi Position" is set to "No", follow the procedure below for measurement. • Do not stand between the speakers and the YPAO microphone during the measurement process (about 5 minutes). • Move to the corner of the room or leave the room. • If any error message (such as E-1) or warning message (such as W-1) appears, see "Error messages" (p.59) or "Warning messages" (p.60). 1 To start the measurement, use the cursor keys to select "Measure" and press ENTER. The measurement will start in 10 seconds. Press ENTER again to start the measurement immediately. • To cancel the measurement temporarily, press RETURN. The following screen appears on the TV when the measurement finishes. (RX-V2075) (RX-V3075 [when angle measurement is disabled]) Proceed to Step 3. (RX-V3075 [when angle measurement is enabled]) Proceed to Step 2. 2 Perform the angle measurement. a Use the cursor keys to select "YES" and press ENTER. Select "NO" to cancel the angle measurement. b Place the supplied microphone base at the listening position and set the YPAO microphone to the position "1". Microphone base FRONT DIRECTION • We recommend using a tripod to place the microphone base at ear height. Use the tripod screws to fix the microphone base in place. • Do not move the microphone base until the third angle measurement finishes. PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 53