Yamaha V2075 RX-V3075/V2075 Owners Manual - Page 55

1 2 3 4 5 6 7 8 9 Automatic speaker setup SOURCE RECEIVER AV 1 2 3 5 6 7 AUDIO 1 2 3 PHONO TUNER 1 MULTI USB [ A ] [B] SCENE 2 3 4 V-AUX 4 NET [ C ] 4 PROGRAM MUTE VOLUME TOP MENU ON SCREEN POP-UP/MENU OPTION ENTER RETURN DISPLAY MODE Cursor keys ENTER RETURN PRESET INPUT MUTE CLASSICAL MOVIE TV TV VOL LIVE CLUB STEREO TV CH ENTERTAIN STRAIGHT PURE DIRECT Measuring at multiple listening positions (multi measure) When "Multi Position" is set to "Yes", follow the procedure below for measurement. • Do not stand between the speakers and the YPAO microphone during the measurement process. It takes about 15 minutes to measure 8 listening positions. • Move to the corner of the room or leave the room. • If any error message (such as E-1) or warning message (such as W-1) appears, see "Error messages" (p.59) or "Warning messages" (p.60). 1 To start the measurement, use the cursor keys to select "Measure" and press ENTER. The measurement will start in 10 seconds. Press ENTER again to start the measurement immediately. • To cancel the measurement temporarily, press RETURN. The following screen appears on the TV when the measurement at the first position finishes. 3 When the measurements at the positions you want to measure are completed, use the cursor keys to select "CANCEL" and press ENTER. When you have taken measurements at 8 listening positions, the following screen appears automatically. (RX-V2075) (RX-V3075 [when angle measurement is disabled]) Proceed to Step 5. (RX-V3075 [when angle measurement is enabled]) Proceed to Step 4. 2 Move the YPAO microphone to the next listening position and press ENTER. Repeat Step 2 until measurements at all listening positions (up to 8) have been taken. PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 55