Yamaha WX-010 WX-010 Owners Manual - Page 10

TURNING ON THE POWER ■ To mount the unit to a wall mount hanger The unit can be mounted to the wall using a commerciallyavailable wall mount hanger. Use the wall mount hanger hole on the rear panel to mount. y Use a wall mount hanger that is compatible for a unified coarse screw, such as those used for the tripod stand of a camera. Rear panel 60 mm (2-3/8") 58mm (2-1/4") WX-010 Specification of mounting screw: UNC 1/4-20 Diameter 6.35 mm (1/4") Screw thread 20 (per 1") 160 mm (6-1/4") WX-010 1.7 kg (3.7 lbs.) 120 mm (4-3/4") Minimum 5 mm (1/4") Specifications of the screw hole Diameter Depth 6.35 mm (1/4") 9 mm (3/8") Note • If using a wall mount hanger, use the one compatible for this unit. • Use the wall mount hanger whose withstand load capacity is over 4.5 kg (10 lbs.). • Follow the instructions in the owner's manual of the wall mount hanger and mount the unit correctly. • If you mount the unit incorrectly or use a wall mount hanger that is not compatible for the unit, the unit may fall and cause injury. • Check the safety after mounting the unit. Yamaha is not responsible for any accidents which may be caused due to an incorrect installation position or incorrect installation methods, or for any malfunction of the wall mount hanger. If you are worried about the safety, ask a professional to install. TURNING ON THE POWER Rear pannel Power cable Top pannel Power indicator " Plug the power cable into the wall outlet and tap (power)/CONNECT. The unit turns on and the power indicator lights. If you tap again, the unit turns off (standby) and the power indicator turns off. Note • After the power plug is inserted into the wall outlet, it takes about 10 seconds for the touch sensors to be adjusted. In order to prevent malfunction of the touch sensors, do not touch them ( (power)/CONNECT/ / / ) or play back for about 10 seconds. y Auto Standby If about 20 minutes have elapsed with no playback and no operation while the unit is on, it will automatically enter standby. You can change the auto standby function setting in the MusicCast CONTROLLER app (☞ P.7). Tap (Settings) in the room select display, and then change the setting. Tap (power)/CONNECT. 5