Yamaha WX-010 WX-010 Owners Manual - Page 9
PREPARATION, INSTALLATION, Mounting the unit on a wall (Except for U.S.A. and Canada model)
View all Yamaha WX-010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PREPARATION INSTALLATION Plug the power cable into the wall outlet after completing installation. Note • Placing the unit too close to a CRT TV may impair the picture color or cause a buzzing noise. In this case, move the unit at least 20 cm (8") away from the TV. This is not an issue with LCD and plasma TVs. • Install in a stable place, being careful of the following points: - Do not place on top of steel or other metal plates. - Do not cover with a cloth, etc. Mounting the unit on a wall (Except for U.S.A. and Canada model) You can mount the unit on the wall as follows. # " Wall/wall support 5 mm (1/4") Minimum 20 mm (3/4") WX-010 1.7 kg (3.7 lbs.) " Install screw (commercially available) into a solid wall or wall support as shown in the illustration. Use 3.5 to 4 mm (1/8") diameter self-tapping screw. # Hang the unit by its keyhole slot onto the protruding screw. Note • Make sure the shaft of the screw is seated in the narrow part of the keyhole slot. Otherwise, the unit may fall. • Do not mount the unit on thin plywood or on a wall with a soft surface material. Otherwise, the screw may pull out of the surface and the unit may fall, possibly damaging the unit or causing personal injury. • Do not affix the unit to a wall using nails, adhesives, or unstable hardware. Long-term use and vibration may cause the unit to fall. • To avoid accidents resulting from tripping over loose cables (such as a power cable), affix the cables to the wall. • When using the brackets to mount the unit on a wall / ceiling, please use safety wire (not included) between the unit and the bracket to prevent the unit from falling. • If you are not sure of a safe way to install the unit, consult a professional installer or a building contractor. • To prevent the vibration from the sound from reaching the wall, attach the Anti-vibration pads on the four corners of the rear panel (☞ P.2). 4