Yamaha XP7000 Owner's Manual - Page 11

Connection ■ Using a Euroblock connector If cables will be frequently connected and disconnected, as in the case of a portable installation, we recommend that you use ferrules with insulation sleeves. Use a ferrule whose conductor portion has an external diameter of 1.6mm or less, and a length of approximately 7 mm (such as the AI0,5-6WH made by the Phoenix Contact corporation). 1 If the wire insertion ports are closed, turn the screws on top of the connector counterclockwise to open the ports. 2 Insert the wires into the appropriate ports, following the indication of the pole on the input terminal, turn the screws on top of the connector clockwise to fix the wires. 3 Attach the Euroblock connector to the input terminal on the unit. Use a screwdriver to fix the wires. -G + ■ Speaker Connection ● 5-way binding post 1 Turn off the POWER switch. 2 Remove the cover attachment screws and remove the protective cover from the speaker terminals. Screw Be sure that the bare wire ends do not jut out from the terminals and touch the chassis. Chassis Bare wire 3 Remove about 15 mm of insulation from the end of each speaker cable. Pass the bare wire through the holes in the appropriate speaker terminals. Tighten the terminals to securely clamp the wires. Refer to page 8 for speaker polarities. 4 Reattach the protective cover over the speaker terminals. 15mm* * Actual size Speaker cable ● Speakon connector 1 Turn off the POWER switch. 2 Insert the Neutrik NL4FC plugs into the Speakon con- CHANNEL Å STEREO or PARALLEL BRIDGE nector on the rear of the amplifier, and turn clockwise to lock. 1+ A+ 1- A- 1+ + 1- Neutrik NL4FC plugs 2+ B+ 2+ - 2- B- 2- CHANNEL ı 1+ B+ 1- B- XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual 11