Yamaha XP7000 Owner's Manual - Page 7
Rear Panel, MONITOR/REMOTE terminals - amp
View all Yamaha XP7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
■ Rear Panel 4 3 56 7 12 7 8 1 XLR inputs connectors These balanced XLR-3-31 type connectors are used to connect input signals. The pins are wired as shown below (IEC 60268). Hot Ground Cold * In bridged mode, only the first channel in the pair is active; i.e., channel A of pair A/B. Make sure not to input an audio signal to an inactive input terminal. 2 Euroblock connectors These balanced Euroblock connectors are used to connect input signals. 3 HPF switches These switches are used to turn on and off the HPF (High Pass Filter) for each channel. When this is set to 20Hz or 55Hz, frequencies below the respective settings are filtered using a 12 dB/octave high pass filter. 4 GAIN switch This switch is used when changing the Gain of the A and B channels simultaneously. • +4dBu: The maximum output power can be obtained when +4dBu is input. • 26dB: Setting of 26dB • 32dB: Setting of 32dB 5 MODE switch • STEREO mode In STEREO mode, channels A and B are completely independent. • PARALLEL mode In PARALLEL mode, the channel A input signal is sent both to the channel A power amp and the channel B power amp. In this case, loads are automatically connected between the A and B input terminals. • BRIDGED mode In BRIDGED mode, channels A and B operate simultaneously, functioning as a single mono amplifier. Note: When in PARALLEL and BRIDGED modes, input terminals A and B are shorted automatically. Make sure not to input an audio signal to an inactive input terminal. 6 MONITOR/REMOTE terminals This terminal is used to connect the external device for monitoring or remote control. Refer to "MONITOR/ REMOTE PIN layout" on page 15. 7 SPEAKERS terminals 1: These 5-way binding posts are used to connect speakers. 2: These are Speakon type output jacks. Speakon type cable plugs can be connected here. 8 GND terminal If you are having a problem with hum or noise, use this terminal to connect to ground (earth) or to connect to the chassis of a mixer, preamp, or other device in your system. XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual 7