Yamaha YAS-201 Owners Manual - Page 13

Remote control Problem Cause Remedy The sound bar cannot The sound bar is out of the operating be controlled using range. the remote control. The batteries are weak. Use the remote control within the operating range (p.8). Replace with new batteries (p.8). The remote control sensor of the Adjust the lighting angle, or reposition the sound bar is exposed to direct sunlight sound bar. or strong lighting. The TV cannot be controlled using the TV remote control. The remote control sensor of the TV is Use the TV Remote Repeater function (p.11) or blocked by the sound bar. remove the stands of the sound bar so that the TV remote control sensor is not blocked (p.6). There may be any problem with the TV or TV remote control. Refer to the manuals of the TV. The TV cannot be controlled by using the TV Remote Repeater function. The TV Remote Repeater function is disabled. The TV remote control does not use infrared signals. (Some remote controls may not work even if it uses infrared signals.) Enable the TV Remote Repeater function (p.11). The TV Remote Repeater function cannot be used in this case. Adjust the position of the sound bar so that the remote control sensor of the TV is not blocked by the sound bar and use the TV remote control to operate the TV. The sound bar and TV are too close or too far from one another. Move the sound bar to adjust the distance between the TV Remote Repeater and TV (remote control sensor) (p.11). If necessary, remove or attach the stands of the sound bar (p.6). There is any obstacle (such as cables) Remove the obstacle between the sound bar between the sound bar and TV. and TV. The sound bar does not learn TV remote control operations. The TV remote control key was not held down long enough. The TV remote control does not use infrared signals. (Some remote controls may not work even if it uses infrared signals.) Hold down the key for more than 1 second twice or three times (p.10). The TV remote control learning function cannot be used in this case. Use the supplied remote control to operate the sound bar. The position where you operated the Operate the TV remote control at the TV remote control is not appropriate appropriate position (p.10). The batteries of the TV remote control Replace with new batteries. are weak. The remote control sensor of the Adjust the lighting angle, or reposition the sound bar is exposed to direct sunlight sound bar. or strong lighting. The transmission of the remote control Turn off the TV and perform the learning signal was disturbed by the TV screen operation again (p.10). light. Sound is coming from the TV when the sound bar volume is turned up with the TV remote control. (when TV remote control learning function is used) Audio output is enabled on the TV. Change the TV setting to disable the TV speaker output. If a setting to disable the speaker output is not available on your TV, try the following methods. - Connect headphones to the headphone jack on the TV. - Set the TV volume to minimum. The power of the sound bar and of the TV switch in the opposite direction. (For example, the TV is turned off if the sound bar is turned on.) (when TV remote control learning function is used) The power of the TV was on when you Press the power key on the TV and (power) performed the learning operation. on the front panel of the sound bar to turn on them and then press the power key on the TV remote control to turn off them. 13