Yamaha YSP-2200 Owners Manual - Page 19

PREPARATION CONNECTION/ INITIAL SETTINGS PLAYBACK Initial settings Auto setup for appropriate surround effects (IntelliBeam) This unit creates a sound field by reflecting sound beams on the walls of your listening room and by broadening the cohesion of all the channels. Just as you would arrange the speaker position of other audio systems, you need to set the beam angle to enjoy the best possible sound from this unit. This unit employs the beam optimization and sound optimization features with the aid of the supplied IntelliBeam microphone, allowing you to avoid troublesome listening-based setup and achieving highly accurate sound adjustments that best match your listening environment. We call these two features "IntelliBeam" generically. Beam optimization: This feature optimizes the beam angle so that the parameter best matches your listening environment. Sound optimization: This feature optimizes the beam delay, volume, and quality so that the parameters best match your listening environment. This unit performs these two automatic optimizations with the aid of the supplied IntelliBeam microphone. 2) Notes • The AUTO SETUP procedure may not be run successfully if this unit is installed in one of the rooms described in "Installing this unit" on page 11. In such cases, run MANUAL SETUP (☞p. 20) to manually adjust the corresponding parameters. • Do not connect the IntelliBeam microphone to an extension cable as doing so may result in an inaccurate sound optimization. • After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone. • The IntelliBeam microphone is sensitive to heat. - Keep the IntelliBeam microphone away from direct sunlight. - Do not place the IntelliBeam microphone on top of this unit. Make sure that there are no obstacles between the IntelliBeam microphone and the walls in your listening room as these objects obstruct the path of sound beams. However, any objects that are in contact with the walls will be regarded as a protruding part of the walls. IntelliBeam microphone Upper limit Center height of this unit Cardboard microphone stand 1.8 m (6.0 ft) or more Within 1 m (3.3 ft) Within 1 m (3.3 ft) Listening position Lower limit Center line IntelliBeam microphone Installing the IntelliBeam microphone 1 Place the IntelliBeam microphone on a flat level surface at your normal listening position. Use the supplied cardboard microphone stand or a tripod to place the IntelliBeam microphone at the same height as your ears would be when you are seated. ■ Assembling the supplied cardboard microphone stand 1 2 3 Fit in Remove Fit in Cardboard microphone stand 2 Check if a video pin cable is connected. Place 4 horizontally 5 Run through SETTINGS TROUBLESHOOTING APPENDIX 2) y • "BEAM+SOUND OPTIMIZE" screen appears automatically when the IntelliBeam microphone is connected. "BEAM OPTIMIZE ONLY" or "SOUND OPTIMIZE ONLY" can be selected separately in setup menu (☞p. 20). • Data set automatically can be saved in the system memory (☞p. 22). You can save the several data depending on listening room and you can change the setting conveniently. 17 En