Yamaha YSP-2200 Owners Manual - Page 27

PREPARATION CONNECTION/ INITIAL SETTINGS Initial settings Setting the HDMI control function 1 Turn on all components connected to this unit with HDMI. 2 Check all components connected with HDMI and enable the HDMI control function on each component. For this unit, set "HDMI CONTROL" to "ON" (☞p. 43). 2) For external components, refer to the manual supplied with each component. 3) 3 Turn off the TV and then turn on it again. Registering HDMI components to TV 4) 1 Select this unit as the input source of the TV. 2 Turn on the HDMI control function supported component (example: Blu-ray disc player) connected to this unit. 3 Select the input source of this unit to Bluray disc player and check whether the image in the player is correctly displayed or not. When connecting Blu-ray disc player with HDMI 1 jack, press input selector key once to show the following diagram. Input source name HDMI1 4 Check if the HDMI control function works (turn on this unit or adjust the volume level using the remote control of the TV). If the HDMI control function is not working Check the following: - The TV is connected to the HDMI OUT (ARC) jack of this unit. - "HDMI CONTROL" (☞p. 43) is set to "ON" in setup menu. - The HDMI control function is enabled on the TV. (Also check the relative settings such as power interlock function or speaker priority.) The HDMI control function is not working even checking the above, - Turn off this unit and the TV, and then turn them back on again. - Disconnect the AC power supply cable of the unit and external components connected to the unit with HDMI. Plug them in again after about 30 seconds. - After selecting INPUT1, INPUT2, INPUT3 or DOCK, change the input of TV and the one of this unit to the same input. Changing the connection method and connected components When the connected components and jacks are changed, reset this unit with following procedures. 1 Turn off the HDMI control function of the TV and player, turn off all connected devices, and change the connections. 2 Perform the step 1 to 3 of "Setting the HDMI control function". PLAYBACK SETTINGS TROUBLESHOOTING APPENDIX 2) y • The default setting is "OFF". When "HDMI CONTROL" is set to "ON" in setup menu, - Even you press key, the power does not completely turned off and the signal outputs from the HDMI IN jack to HDMI OUT (ARC) jack. - Before turning off the unit, select desired input sources connected to HDMI IN (1 to 3). - According to the TV, the TV operation such as changing the channel may change the setting of surround modes of this unit. 3) y The example of TV settings • From a setup menu on your TV, select "Link setting"  "HDMI control setting" (example), then set a setting such as "HDMI control function" to "ON" (example). • Setting such as "Speaker priority" should be set to "AV amplifier". 4) y For some HDMI components, you only need to set the HDMI control function. Registering HDMI components to TV is not required in this case. 25 En