Yamaha YST-SW200 Owner's Manual - Page 9

– POWER indicator Illuminates when the POWER switch is turned ON, and goes off when turned OFF. * STANDBY mode (Australia, U.K. and Europe models) While the power is on, pressing the POWER key on the remote control transmitter switches the unit to the STANDBY mode. (In this mode, the indicator is half illuminated.) POWER /STANDBY POWER POWER /STANDBY POWER › VOLUME control Adjusts the volume level. For easier operation, use the VOLUME UP/DOWN keys on the remote control transmitter. œ PHASE switch Normally this switch is to be set to the normal (NOM) position. However, according to your speaker systems or the listening condition, there may be a case when better sound quality is obtained by setting this switch to the reverse (REV) position. Select the better position by monitoring the sound.  OUTPUT switch Turns the output of this unit ON and OFF whenever pressed. When this switch is turned ON, the OUTPUT indicator on the front panel illuminates. POWER on mode STANDBY mode — OUTPUT indicator Illuminates when the OUTPUT switch is turned ON, and goes off when turned OFF. ˜ Remote control sensor Receives the signals from the remote control transmitter. ™ POWER switch Turns the power of this unit ON and OFF whenever pressed. When this switch is turned ON, the indicator over the POWER switch on the front panel illuminates. š HIGH CUT control Adjusts the high frequency cut off point. Frequencies higher than the frequency selected by this control are all cut off (and not output). For easier operation, use the HIGH-CUT 90 80 100 UP/DOWN keys on the remote control 70 110 transmitter. 60 120 * One graduation of this control indicates 50 10 Hz. 40 Hz 130 140 Hz 9