Yamaha YV-1605J Owner's Manual - Page 14

Assembly ⁄6 Height Adjustment Height adjustment should always be performed by at least 2 persons. To adjust the height of the tone bars, first remove the round belt (fan belt), driver, controller and tone bars*, and loosen the center rod fixing bolts. (* To remove the tone bars, disengage the springs on the low sound side, and then unhook the string from the post.) Support both frame ends by hand (do not touch the metal parts shown in the illustration), and loosen the slide leg fixing bolts. Frame For height adjustment, make sure to support the instrument by the wooden frame. Do not touch the metal parts. Do not touch ! Lift the frame ends to the desired height and then securely tighten each slide leg fixing bolt, aligning it with the corresponding notch of the slide leg. Bolt and notch are aligned when the next higher notch is flush with the upper leg flange. (Refer to step m on page 24.) When a slide leg fixing bolt is tightened in between two notches, there is a danger of the slide leg slipping. Always make sure that the slide legs are held securely. ⁄7 This completes the assembly of the instrument. To play, connect the supplied AC adapter to the DC 12-15V IN jack of the controller. 29