Yamaha YV-1605J Owner's Manual - Page 9

Assembly m Connect the slide legs with the legs. Align the legs from above so that the slide legs slide into the corresponding leg holes. Adjust to the desired height and then securely tighten each slide leg fixing bolt, aligning it with the corresponding notch of the slide leg. Fixing bolt and notch are aligned when the next lower notch is flush with the upper leg flange. Align notch with upper flange. Do not touch the notched part during height adjustment to avoid injury. * The fourth notch from the tone bar side corresponds to the standard height setting. High Sound Side When a slide leg fixing bolt is tightened in between two notches, there is a danger of the slide leg slipping. Always make sure that the slide legs are held securely. Low Sound Side , After fixing the legs, connect the pedal with the sustain damper. Loosen the center rod fixing bolts to extend the center rod, and insert the center rod into the fitting of the rod connector. Align the groove in the center rod with the tip of the fixing bolt, and then securely tighten the fixing bolt. Rod Connector Groove Tighten Center Rod Pedal Rod 24