Zanussi ZBB24430SA Product Manaul - Page 11
Ventilation requirements, Installing the appliance - installation
View all Zanussi ZBB24430SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
x 2 x 1 Loosen the upper pin and remove the spacer. Remove the upper pin and the upper door. Loosen the middle hinge. On the opposite side: Install the lower pin. Install the lower door. Install the upper door. Tighten the spacer and the upper pin. Remove the lower door. Loosen the lower pin. Ventilation requirements The airflow behind the appliance must be sufficient. 5 cm min. 200cm2 min. 200cm2 Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: www.zanussi.com 1 If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. 2 Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. I 4mm 44mm I 3 Adjust the appliance in 4 Attach the appliance to the niche. the niche with 4 screws. Make sure that the dis- tance between the appli- ance and the cupboard front-edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the dis- tance between the appli- ance and the kitchen furni- ture is correct. Make sure that the clear- ance between the appli- ance and the cupboard is 4 mm. Open the door. Put the lower hinge cover in posi- tion. 11