Zanussi ZBB24430SA Product Manaul - Page 12
Ha, Hb, Hc and Hd.
View all Zanussi ZBB24430SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
C D E E B 5 Remove the correct 6 Attach the covers (C, part from the hinge cover D) to the lugs and the (E). Make sure to remove hinge holes. the part DX, in the case of Install the vent grille (B). right hinge, SX in opposite Attach the hinge covers (E) case. to the hinge. Ha Hb G H 8 mm 8 mm K Ha Hb Ha 11 Open the appliance 12 Remove the brackets door and the kitchen furni- and mark a distance of 8 ture door at an angle of mm from the outer edge of 90°. the door where the nail Insert the small square must be fitted (K). (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Hc Hd 7 Connect the appliance 8 Disconnect the parts laterally to the kitchen fur- (Ha), (Hb), (Hc) and (Hd). niture sidewall: 1. Loosen the screws of the part (G) and move the part (G) till the furniture sidewall. 2. Tighten the screws of the part (G) again. 3. Attach the part (H) to the part (G). ~50 mm 90o Ha 21 mm 90o ~50 mm 21 mm Hc 9 Install the part (Ha) on 10 Push the part (Hc) on the inner side of the kitch- the part (Ha). en furniture. Hb Hb Hd 13 Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. 14 Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet. Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases. 12 www.zanussi.com