Zanussi ZDC68560W Product Manaul - Page 13

operation when the machine is next used. The Water reservoir light reminds you to perform this operation. 1. To open the door, push the catch as per picture. During the drying cycle or at the end, it is normal for water to be present on the surface of the condenser insertion. 2. Turn the two red stops downwards. 3. Pull out the condenser unit holding it at the handle . 4. Clean it with a brush and rinse it under the shower if necessary. Also clean the outside, removing all fluff. Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth. Important! Do not use pointed objects or utensils to clean the spaces between the plates, as this could damage the condenser and make it permeable. Re-fit the condenser, turn the red stops upwards and close the door. Important! Do not use this appliance if the condenser has not been fitted. Emptying the water reservoir Water extracted from the laundry condenses inside the machine and is collected in a reservoir. The reservoir must be emptied after each drying cycle to ensure efficient 1. Pull out the reservoir 2. Turn it upside down and let water empty 3. Re-fit the reservoir Important! The reservoir must be re-inserted correctly. If this is not done the pilot light Water reservoir comes on during next drying and the programme stops, leaving the laundry damp. The buzzer will sound. After inserting the reservoir press the Start/Pause button again to allow the programme to continue. The condensed water may be used in a steam iron or to top up a battery, etc. In this case it must be filtered (e.g. through a coffee filter). Cleaning the drum Caution! Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the appliance. Use a standard domestic cleaner (e.g. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean control panel and housing Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the control panel and housing. 13