Zanussi ZIAN644K User Manual - Page 5
Installation
View all Zanussi ZIAN644K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WARNING! Risk of damage to the appliance. • Do not keep hot cookware on the control panel. • Do not put a hot pan cover on the glass surface of the hob. • Do not let cookware boil dry. • Be careful not to let objects or cookware fall on the appliance. The surface can be damaged. • Do not activate the cooking zones with empty cookware or without cookware. • Do not put aluminium foil on the appliance. • Cookware made of cast iron, aluminium or with a damaged bottom can cause scratches on the glass / glass ceramic. Always lift these objects up when you have to move them on the cooking surface. • This appliance is for cooking purposes only. It must not be used for other purposes, for example room heating. CARE AND CLEANING • Clean the appliance regularly to prevent the deterioration of the surface material. • Deactivate the appliance and let it cool down before you clean it. INSTALLATION • Disconnect the appliance from the electrical supply before maintenance. • Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Use only neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. SERVICE • To repair the appliance contact the Authorised Service Centre. • Use original spare parts only. DISPOSAL WARNING! Risk of injury or suffocation. • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. • Cut off the mains electrical cable close to the appliance and dispose of it. WARNING! Refer to Safety chapters. ASSEMBLY BEFORE THE INSTALLATION Before you install the hob, write down the information below from the rating plate. The rating plate is on the bottom of the hob. Serial number BUILT-IN HOBS Only use the built-in hobs after you assemble the hob into correct built-in units and work surfaces that align to the standards. CONNECTION CABLE • For a single phase or two phase connection, use the cable type: H05BB-F or H03V2V2-F which withstands a temperature of 70 °C or higher. • To replace the damaged mains cable, use the cable: H05BB-F or H03V2V2-F which withstands a temperature of 70 °C or higher. min. 500mm min. 50mm 5