Zanussi ZWG6161P Product Manaul - Page 25

Malfunction Possible cause / Solution Spinning starts late or the appliance does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the appliance will not spin. In this case, redistribute the load manually and select the spin programme. • Load more laundry. The load is too small. • Add more items, redistribute the load manually and then select the spinning programme. No water is visible in the drum: Appliances based on modern technology operate very economically using very little water without affecting performance. Too little detergent or unsuitable detergent has been used. • Increase the detergent quantity or use another one. Stubborn stains have not been treated prior to washing. Unsatisfactory washing results • Use commercial products to treat the stubborn stains. The correct temperature was not selected. • Check if you have selected the correct temperature. Excessive laundry load. • Reduce the laundry load. The appliance makes an unusual noise The appliance is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the appliance. After completing these checks, switch on the appliance and press the button 6 to restart the programme. If the malfunction shows again, contact your Service Centre. The necessary data for the service centre is on the rating plate. We recommend that you write the data here: Model description (MOD Product number (PNC Serial number (S.N Ser. No . . ... ... ... ... ProMdo.d.N..o.. Mod Prod. No Ser. No 25