Zenith SL-4192-BK User Guide - Page 3

WIRING Note: All wiring should be run in accordance with the National Electrical Code through conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of the system. CAUTION: DO NOT connect the RED wire unless you want to control other lights from the motion sensor. ❒ Twist the junction box wires and the fixture wires together as shown below. Secure with wire connectors. If you have a metal junction box, you may not need the green "pigtail". If you are unsure about the grounding method, consult your local building code. Connect the fixture wires to the wires in the junction box. Twist the wires together and secure with wire connectors. Black Green or Bare White One Motion Light Light Fixture White Black Green or Bare Light Fixture Light Fixture Two Motion Lights Recommended Grounding Method Use a green ground "pigtail" (not provided) and twist one end together with the bare fixture wire and the box ground wire. Secure with a wire connector. Secure the other end of the "pigtail" with the GND screw on the X-bar. Black to black White to white 595-5628-08