Zenith SL-4192-BK User Guide - Page 7
Specifications, Troubleshooting Guide
UPC - 016963419223
View all Zenith SL-4192-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
SPECIFICATIONS Range Up to 30 ft. (9.1 m) [varies with surrounding temperature] Sensing Angle. . . . . . Up to 180° Electrical Load. . . . . . See rating on fixture for maximum wattage Sensor Capacity . . . . Upto360Watts(3.0A.) Maximum Tungsten Incandescent Power Requirements 120 VAC, 60 Hz Operating Modes. . . . TEST, AUTO, and MANUAL MODE Time Delay 1, 5, 10 minutes DualBrite® Timer. . . . Off, 3, 6 hours, dusk-to dawn HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. TROUBLESHOOTING GUIDE SYMPTOM Light will not come on. Light comes on in daylight. Light comes on for no apparent reason. POSSIBLE CAUSE 1. Light switch is turned off. 2. Bulb is loose or burned out. 3. Fuse is blown or circuit breaker is turned off. 4. Daylight turn-off is in effect (recheck after dark). 5. Incorrect circuit wiring, if this is a new installation. 1. Light control may be installed in a relatively dark location. 2. Light control is in Test. (Set control switch to an ON-TIME position.) 1. Lightcontrolmaybesensingsmall animals or automobile traffic (Reduce sensitivity). 2. Sensitivity is set too high. (Reduce sensitivity.) SYMPTOM Light stays on continuously. Light flashes on and off. POSSIBLE CAUSE 1. The sensor is pointed toward a heat source like an air vent, dryer vent, or brightlypainted heat-reflective surface. (Reduce sensitivity.) 2. Light control is in Manual Mode. (Switch to Auto.) 3. Light control is in DualBrite® mode. 4. Sensitivity is set too high. (Reduce sensitivity.) 1. Light control is in the Test mode and warming up. (Flashing is normal under these conditions). 2. Heat being reflected from other objects may be affecting the sensor. (Reduce sensitivity.) 595-5628-08