Zenith SL-5210 User Guide - Page 2

INSTALLATION ❒ Plug the sensor cord into the switch module. The sensor cord's plug is polarized for proper installation. IMPORTANT: TURN OFF THE POWER TO THE LIGHTING ❒ Place the Switch Module into the junction box. Before CIRCUIT AT THE CIRCUIT BREAKER OR FUSE BOX to mounting the fixture cover, make sure that the cord is flat avoid electrical shock. and smoothly placed against the wall so that the cord will ❒ Remove the fixture and fixture strap (if present) and disconnect the wiring. not be damaged when the fixture is re-installed. Make sure that the protective sleeve over the sensor cord extends slightly beyond the fixture cover. ❒ Reinstall the fixture. Circuit Breaker or Fuse Box Turn power off before wiring! Switch Wire Connectors Black Black Black White White Fixture Red Black White To Light Fixture 4" x 4" Junction Box House Wiring Sensor Wiring Light Control Switch Module In Junction Box Typical Wiring • Connect the RED light control wire to the BLACK fixture wire. • Connect the BLACK house wire to the BLACK light control wire. • Connect the WHITE light control wire to both the WHITE house wire and the WHITE fixture wire. If used, join the grounding wire from the power source to the fixture grounding wire (usually a bare wire). Secure at the junction box grounding screw. Connect additional lamps (up to 500 W.) to the white and red control wires. Drip Loop Mounting Sensor ❒ Attach the sensor module to the wall with the screws provided. Place the sensor below or to the side of the fixture. It may be necessary to tilt the sensor head up while mounting. Important Installation Information When installing the sensor, make sure the wire comes out of the bottom of the bracket and forms a "drip loop" (shown above). This will prevent water from entering the sensor head or junction box.  595-4991-07