Zenith SL-5511-BZ User Guide - Page 3

TEST AND ADJUSTMENT ❒ Turn on the circuit breaker and light switch. NOTE: Sensor requires about 1 1/2 minutes to calibrate before it will detect motion. When first turned on, wait about 1 1/2 minutes. ❒ Turn the SENSITIVITY (SENS) control to the mid position and the ON-TIME control to the TEST position. ON-TIME SENS 10 5 1 TEST MIN MAX Bottom of Sensor Avoid aiming the control at: • Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering. • Areas where pets or traffic may trigger the control. • Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor. 8 ft. (2.4 m) 110° ❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor to aim. ❒ Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the coverage area. Keep the sensor at least 1" (25 mm) away from the lamps. ❒ Set SENSITIVITY as needed. Too much sensitivity may increase false triggering. Clamp Ball Joint Aim Sensor Down for Short Coverage ❒ Secure the sensor head into position by tightening the clamp screw. Do not overtighten the screw. ❒ Set the amount of TIME the Aim Sensor Higher for Long Coverage lights stay on after motion is detected. It is selectable from 1, 5, or 10 minutes. SPECIFICATIONS Range Up to 60 ft.(18.3 m);[varies with surrounding temperature] Sensing Angle Up to 110° Electrical Load Up to 150 Watts Maximum tungsten Power Requirements. . . 120 VAC, 60 Hz Operating Modes. . . . . . TEST, AUTO and MANUAL MODE Time Delay 1, 5, or 10 minutes Sensitivity Adjustable Replacement lamp. . . . . T 150W (or less) halogen 120 VAC Maximum Range 60 ft. (18.3 m) Maximum Coverage Angle HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. The control is most sensitive to motion across it. Motion Motion Sensor Least Sensitive Most Sensitive 595-5574-06