2010 BMW X3 Owner's Manual - Page 115
2010 BMW X3 Manual
Page 115 highlights
For bulb replacement procedure, refer to Driver's side. Parking and roadside parking lamps W5W bulb, 5 watts A bulb is located over each high beam. At a glance Reference Mobility 113 Driving tips Controls Lamp PSY24W, 24 Watt or PSY24W Silver Vision* Access to the turn signal is at the edge of the lamp unit, refer to arrow. Make sure that the lamp base does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered.< 1. Turn the lamp base and remove it. 2. Replace the bulb. 3. Insert the lamp base. If it does not snap into place immediately, turn the lamp base until it does. 1. Remove bulb cover for high beams, refer to Halogen high beams. 2. Remove bulb holder. 3. Remove and replace the bulb. Halogen high beams H7 bulb, 55 watts Always wear gloves and eye protection - the atmosphere inside the H7 bulb is pressurized. Failure to observe this precaution can lead to injuries should the bulb be damaged.< For checking and adjusting headlamp aim, please contact your BMW Sports Activity Vehicle Center.< Turn signal, front Driver's side 1. Open the clip and remove the lamp cover. 2. Press the bulb holder downward and remove, refer to Low beams. 3. Pull off the lamp base; plug in a new lamp base. 4. Place the lamp base with the lower edge against the bracket and press it in until the lamp base locks into place. Make sure that the cover does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered.< Front passenger side Before replacing the bulb, remove the reservoir of the windshield washer system from the bracket, refer to Halogen low beams on page 112. For bulb replacement procedure, refer to Driver's side. Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG