2010 BMW X3 Owner's Manual - Page 116
2010 BMW X3 Manual
Page 116 highlights
Replacing components Side-mounted turn signals W5W bulb, 5 watts 1. Use finger pressure against the rear end of the lamp, refer to arrow, to press it forward for removal. 6. Install in the reverse order. Tail lamps > Turn signal lamp: PY21WSV bulb, 21 watts > Other bulbs: W16W bulb, 16 watts 2. Apply gentle pressure to the bulb while turning it to the left and pull it out. 3. Install in the reverse order. 1 2 3 4 5 Brake lamp Parking lamp/rear lamp, LED Turn signal Backup lamp Rear lamp, LED Front fog lamps H11 bulb, 55 watts Always wear gloves and eye protection - the atmosphere inside the H11 bulb is pressurized. Failure to observe this precaution can lead to injuries should the bulb be damaged.< 1. Pull the cover in front of the fog lamp forward. 2. Loosen the screw, refer to arrow, pivot headlamp out on this side and remove toward the front. In the event of a defect involving the lamps 2, 4 and 5, please consult your BMW Sports Activity Vehicle Center. Changing Open the flap in the side panel, refer to page 78. Turn signal lamp: 3. Turn the lamp base at the back of the headlamp to the left and remove it. 4. Disconnect the cable connector. 5. Slide new bulb onto plug connector; be sure it snaps firmly into place. 114 Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG 1. Turn bulb holder to the left, refer to arrow 1, and remove. 2. Apply gentle pressure to the bulb fitting while turning it to the left, remove and replace.