2010 BMW X3 Owner's Manual - Page 52
2010 BMW X3 Manual
Page 52 highlights
Technology for comfort, convenience and safety Technology for comfort, convenience and safety PDC Park Distance Control* The concept PDC provides extra safety and convenience during parking maneuvers. Audible signals indicate that you are approaching an object in front of or behind your vehicle. To measure the distance, there are four ultrasonic sensors in each bumper. An acoustic signal begins to sound when the front sensors and the rear corner sensors are within approx. 2 ft/60 cm of an obstacle and when the rear middle sensors are within approx. 5 ft/1.50 m of an obstacle. PDC is a parking aid that can indicate objects when they are approached slowly, as is usually the case when parking. Avoid approaching objects too fast; otherwise, the system may give warning of physical obstacles too late.< If you are driving with a trailer, the rear sensors cannot take any meaningful measurements. Consequently, they do not switch on. Activating manual mode In ignition key position 2, press the button; the LED lights up. Deactivating manual mode Press the button again, the LED goes out. The system is automatically deactivated once the vehicle travels approx. 160 ft/50 m or exceeds a speed of roughly 20 mph/30 km/h; the LED goes out. You can reactivate the system manually as needed. Signal tones An intermittent tone from a rear speaker signals the distance to an object behind the vehicle as you approach it. An intermittent tone from a speaker beneath the instrument cluster signals the distance to an object in front of the vehicle as you approach it. As the distance between vehicle and object decreases, the intervals between the tones become shorter. The signal tone becomes continuous once the distance to the nearest object falls to below roughly 1 ft/30 cm. An intermittent tone is interrupted after approx. 3 seconds: > If you remain in front of an object that is only detected by one of the corner sensors > If you are moving parallel to a wall Automatic mode In ignition key position 2, the system is automatically activated after approx. 1 second each time you shift into reverse or move the selectorlever into position R. Wait for one second to pass before moving. You can have a signal tone programmed into the system to verify that the PDC is active.< 50 Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG