1998 Cadillac Seville Owner's Manual - Page 120

Training a Garage Door Opener with "Rolling Codes"(If Equipped) If you have not previously programmed hand-held the transmitter tothe universal transmitter, see "Programming the Transmitter" inthe Index. If you you have completed this programming, need to train the garage door opener receiver to recognize the universal transmitter. Refer to your garage door opener owner's manual for the proper transmitter training procedure for your garage door opener brand. The garage door opener should now recognize the universal transmitter. You may either use the universal transmitter or the hand-held transmitter to open the garage door. If after following these instructions you have still problems trainingthe garage door opener, consult your dealer. Erasing Chan--- To erase all three programmed channels, hold down the two outside buttons until the red light beginsflash. to 1. Locate the training button the garage door opener on Individual channels cannot be erased, but can be receiver. The exact location and color the button of reprogrammed using the procedure programming the for may vary by garage door opener brand. If you have transmitter explained earlier. difficulty locatingthe training button, refer to your garage door opener manual. Accessories Accessories for the universal transmitter available are from the manufacturerof the unit. If you would like 15. additional information, please call 1-800-355-35 2. Press the training button on the garage door opener two receiver for one or seconds. A light indicator will begin to flash when the receiver enters the train mode. 3. Return to the universal transmitterin your vehicle and pressthe universal transmitter button you have already programmed for two to three seconds. Press the button again to make sure that the universal transmitter has been trained to the garage door opener receiver. Check that train was successful. the The receiver light should no longer be flashing. 2-59