1998 Cadillac Seville Owner's Manual - Page 94

Turn SignaVMultifunction Lever 'hrn and Lane Change Signals To signal a turn, move the lever the left side of the on way steering wheel all the up or down. The lever returns automatically when the turn complete. is for Breakers" in the Index) and check burned-out bulbs if the arrow fails work when signalinga turn. to Headlamp High/Low-Beam Changer When the headlampsare on, push the lever to turn the headlamp high beams on, and pullit to the center position to turn on the low beams. This light on the instrument panel will be on, indicating high-beam usage. I A instrument the on An arrow I panel will flash in the direction of the turn or lane change. Flash-To-Pass Raise or lower the lever until the arrow starts flash to to signal a lane change. Hold there until the lane change it is complete. Thelever returns when it's released. If the turn signal left on, a warning chime will sound is and the DIC will display TURN SIGNAL (after ON driving about a mile) remind you to turnit off. to Arrows that flash rapidly when signaling a turn or for lane change may be caused by a burned-out signal bulb. Other drivers won't the turn signal. see Replace burned-out bulbsto help avoid possible accidents. Check the fuse "Fuses and Circuit (see This letsyou use the high-beam headlamps to signal the driver in front you that you want to pass. of Pull the turn signal lever toward you briefly to flash-to-pass. When you do: If the headlamps are either off or in theDRL mode, the high-beam headlamps will turnon. They'll stay on as long as you hold the lever there. Release the lever to turn them off. If the headlamps are on low beam, low beam will remain active and high beam will illuminate also until you release the lever.