1998 Cadillac Seville Owner's Manual - Page 15

A second &or, seating and column position may be programmed by repeating the above steps and pressing button 2. Each time a memory button is pressed,a single beep will sound through the radio. Each time button or 2 1 is pressed, the memory positions will be recalled. At the factory, the exit position is preset with the steering wheel full up and the seatfull back. However, two personalized exit positions can set by first recalling the driving be position (Driver"1" or "2"), positioning the wheel and seat in the desired exit positions and then pressing the MEMORY SET and, within five seconds, pressing the EXIT button. The exit position for either previously set driver canbe recalled by pressing the EXIT button. Push the button oncefor a high setting, twice for a low setting, and a third time to turn the heated seat.The off LO setting warms the seatback and cushion until the seat approximates body temperature.The HI setting heats the seat to a slightly higher temperature. The heated seats can only be used when the ignition is turned on. The heating elementsin the seats automatically turn off when the vehicle's ignition is turned off. Reclining Front Seatbacks The power controls are located on the outboard sideof each front seat. Press the top of the control forward or rearward to adjust the seatback angle. Push up or down to adjust the headrest and shoulder belt. Heated Seat (Option) This option is only available if your vehicle is equipped with the power lumbar control feature. The front seat controls are located in the center console. The rear seat controls, for the outboard positions only, are located on the rear door (note that only the outboard positions in the rear seats are heated).