2012 Cadillac SRX Owner Manual - Page 380

10-40 Vehicle Care License Plate Lamp To replace one of these bulbs: 1. Open the liftgate. See Liftgate on page 2￿14 for more information. A. Bulb Socket B. Bulb C. Lamp Assembly 4. Turn the bulb socket (A) counterclockwise to remove from lamp assembly (C). 5. Pull the bulb (B) straight out of the bulb socket. Passenger Side Shown, Driver Side Similar 2. Push the left end of the lamp assembly towards the right. 3. Turn the lamp assembly down to remove from liftgate. 6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install into lamp assembly. 7. Turn the lamp assembly into the liftgate engaging the clip side first. 8. Push on the lamp side opposite the clip until the lamp assembly snaps into place. Replacement Bulbs Exterior Lamp Back￿up Lamp Daytime Running Lamp Headlamp High-Beam Headlamp Low-Beam License Plate Lamp Turn Signal Front Tail/Turn Signal Rear Bulb Number Hyperclick PH16W 7443 9005 H10 194LL 7440 W21W For replacement bulbs not listed here, contact your dealer.