1998 Chevrolet Astro Owner's Manual - Page 280

Installing the Engine Cover 1. Lift the engine cover into the vehicle and slideit all the way forward. Make sure the rubber seal is over the latches. 2. Install the two bolts at the engine cover. 3. Put the heater duct over the engine cover studs. Push up on the duct gently until it snaps into place. 4. Reconnect the electrical connectors. 9. Grasp the bottom of the cover and slide it rearward. Then, lift it upand out of the vehicle. If the seal does not release, use the pull strap on the driver's side above the rear mount. 5 . Install the engine cover extension by gently squeezing the sides and sliding into place. Make it sure all of the fastener clips engage and the extension fits properly in place. Replace and tighten the two screws. to 6 . Install the two nuts secure the extension in place. 6-18