2006 Chrysler Crossfire Owner's Manual - Page 153
2006 Chrysler Crossfire Manual
Page 153 highlights
STARTING AND OPERATING 153 CAUTION! If the vehicle is towed with the front axle raised (see the What To Do In Emergencies section in this manual), the engine must be shut off (key in the ignition switch turned to the OFF/LOCK or ACC position). Otherwise, the ESP will immediately be engaged and will apply the rear wheel brakes. NOTE: When the ESP warning light is illuminated continuously, the ESP is switched off. Adapt your speed and driving to the prevailing road conditions. NOTE: Avoid spinning of one drive wheel. This may cause serious damage to the drivetrain which is not covered by the DaimlerChrysler Limited Warranty. NOTE: If the ESP warning light flashes during acceleration, ease up on the accelerator. NOTE: ESP should not be switched off during normal driving. Disabling of the system under normal operating conditions will eliminate the benefits of the ESP system. Synchronizing ESP If the power supply was interrupted (battery disconnected or discharged), the BAS/ESP malfunction indicator light may be illuminated with the engine running. To re-synchronize the ESP, and cancel the malfunction indicator light, the steering angle sensor will need to be recalibrated. 1. Turn the ignition switch to the ON/RUN position. 2. Rotate the steering wheel to the center position. 3. Rotate the steering wheel completely to the left, and then rotate the steering wheel completely to the right. 4. Bring the steering wheel back to the center position. 5. The BAS/ESP malfunction indicator light will go out. If the BAS/ESP malfunction indicator light is still illuminated, the vehicle should be serviced at an authorized dealer. 5