2008 Chrysler Sebring Owner Manual Sedan - Page 149

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 147 NOTE: • Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. • After training a HomeLink௡ channel, if the garage door does not operate with HomeLink௡ and the garage door opener was manufactured after 1995, the garage door opener may have a rolling code. If so, proceed to the heading "Programming A Rolling Code System." 4. Press and hold the just-trained HomeLink௡ button and observe the indicator light. If the indicator light stays on constantly, programming is complete and the garage door (or device) should activate when the HomeLink௡ button is pressed. If the indicator light blinks rapidly for two seconds, and then turns to a constant light, continue with programming for a Rolling Code. 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "Learn" or "Training" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open and close the door). 3