2008 Chrysler Sebring Owner Manual Sedan - Page 274
2008 Chrysler Sebring Manual
Page 274 highlights
272 STARTING AND OPERATING BRAKE/TRANSAXLE INTERLOCK This system prevents you from moving the gear selector lever out of PARK and into any gear unless the brake pedal is pressed. This system is active only while the ignition switch is in the ON position. Always press the brake pedal first, before moving the gear selector lever out of PARK. NOTE: If a malfunction occurs, the transaxle will not shift out of PARK. Battery power is required to release the brake/transaxle interlock system. However, there is an override system that allows you to shift out of PARK in case of loss of power. To activate the override system: • Firmly apply the parking brake • Insert the ignition key and rotate it to the ON position • Remove the cup holder liner • Insert a key, screwdriver, or finger into the front hole then push and hold the manual override release lever forward. • While holding the release lever forward, move the gear selector lever from PARK to NEUTRAL. Release the manual override lever. NOTE: If this occurs, even if the override is successful, it is recommended that you visit a dealer at your earliest possible convenience. Your dealer has diagnostic equipment to determine if the problem could recur. AUTOMATIC TRANSAXLE IGNITION INTERLOCK SYSTEM This system prevents the key from being removed unless the gear selector lever is in PARK. It also prevents shifting out of PARK unless the key is in the ON position and the brake pedal is applied.