2009 Chrysler Aspen Owner Manual - Page 183
2009 Chrysler Aspen Manual
Page 183 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 181 3. Continue to press and hold the HomeLink button while you press and release - every two seconds ("cycle") your hand-held transmitter until HomeLink has successfully accepted the frequency signal. The EVIC display will change from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." If you unplugged the device for training, plug it back in at this time. Then proceed with Step 4 under "Programming HomeLink" earlier in this section. Using HomeLinkா To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.) The hand-held transmitter of the device may also be used at any time. Reprogramming A Single HomeLinkா Button To reprogram a channel that has been previously trained, follow these steps: 1. Turn the ignition switch to the ON/RUN position. 2. Press and hold the desired HomeLink button for 20 seconds until the EVIC display states "CHANNEL # TRAINING." Do not release the button. 3. Without releasing the button, proceed with Programming HomeLink Step 2 and follow all remaining steps. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the EVIC message states "CHANNELS CLEARED." Note that all channels will be erased. Individual channels cannot be erased. 3